Search found 4 matches

by Askjerry
Friday 23rd November 2018 9:11pm
Forum: Component
Topic: Gambas --> Beaglebone Black
Replies: 7
Views: 530

Re: Gambas --> Beaglebone Black

Everything seems to point to Python. I have a Raspberry Pi now... and I used GLADE to create a panel... then got an LED to turn on/off with a button. So I accomplished that goal. Likely could do the same with the Beaglebone Black as well. It's a shame... I would have liked to use Gambas... it is a m...
by Askjerry
Saturday 08th September 2018 1:05am
Forum: Component
Topic: Gambas --> Beaglebone Black
Replies: 7
Views: 530

Re: Gambas --> Beaglebone Black

Not really... it was written for the Raspberry Pi, and I have a Beaglebone . The pin configuration is different. Also, I downloaded the files from that page and attempted to open them in Gambas but was unable to do so. Is there a Beaglebone library? Do I need to abandon the Beaglebone and use the Ra...
by Askjerry
Saturday 18th August 2018 9:13pm
Forum: Component
Topic: Animated gauge component
Replies: 3
Views: 1428

Re: Animated gauge component

Very nice! If I can figure out how to connect with the Beaglebone... this could come in useful as a display!

Thank you!
:D
by Askjerry
Saturday 18th August 2018 9:12pm
Forum: Component
Topic: Gambas --> Beaglebone Black
Replies: 7
Views: 530

Gambas --> Beaglebone Black

I just installed Linux and Gambas 3 onto my Beaglebone Black... I have decades of experience with Vidual BASIC... so it didn't take much to make a simple program, run it, compile it and make it installable... But now... how do I access the Beaglebone GPIO to both read the status of a pin and/or set ...